Price elasticity of demand is the percentage change in units sold divided by the percentage change in price that caused it, so a value of negative 2 means a 10 percent price increase cuts units by about 20 percent. Products with an elasticity beyond negative 1 are called elastic, because revenue falls when price rises; products between 0 and negative 1 are inelastic, because revenue rises.
Elasticity is usually taught as a revenue rule: raise prices on inelastic products, cut them on elastic ones. For a seller paying COGS, fulfillment, and marketplace fees on every unit, that rule is incomplete. What matters is contribution, and contribution responds to price differently from revenue because most per-unit costs do not move when price does.
On Amazon, the referral fee is a percentage of the sale price, 15 percent in most categories according to the sell.amazon.com pricing page. The fulfillment fee is set by size and weight, and landed cost is set by the supplier. So each extra dollar of price adds roughly 85 cents of contribution, while each lost unit takes away the whole unit contribution. For a product with thin margins, the lost units cost little and the extra price is worth a lot. That is why a product can be elastic, lose revenue on a price increase, and still make more money.
The useful number is therefore not elasticity alone. It is the break-even elasticity: the volume response at which a given price change leaves contribution unchanged. If the measured elasticity is smaller in size than the break-even figure, the price increase earns more.
Illustrative numbers. Take the SKU from the pricing investigation: an Amazon seller raised the price from $24.99 to $27.99, and over two matched 28-day windows units went from 840 to 690.
Price change: $3.00 on $24.99 is 12.0 percent.
Volume change: 150 fewer units on 840 is negative 17.9 percent.
Simple elasticity: negative 17.9 divided by 12.0 equals negative 1.49. The product is elastic. Revenue fell from $20,991.60 to $19,313.10, an 8.0 percent drop, as the revenue rule predicts.
Break-even elasticity: before ads, each unit contributed about $7.00 at the old price and about $9.44 at the new one. To hold contribution flat at $9.44 per unit, the seller needed 7.00 divided by 9.44 of the old volume, which is 74.2 percent, or about 623 units. That is a 25.8 percent drop. Divided by the 12.0 percent price change, the break-even elasticity is negative 2.15.
The measured negative 1.49 is well inside negative 2.15, so the increase raised contribution. In the pricing investigation, it added $635.23 over 28 days.
A second measurement. In the same weeks of the prior year, with no price change, units fell 6 percent from August to September. Adjusting the baseline to 790 units, the volume change attributable to price is 100 units on 790, or negative 12.7 percent, and the elasticity is negative 12.7 divided by 12.0, which is negative 1.06. Which figure is right depends on whether the seasonal pattern repeated. Either way, the conclusion holds.
A note on method. The simple calculation uses the old price and volume as the base, so a move up and a move back down give different answers. The midpoint method divides each change by the average of the two values: 150 units on an average of 765 is 19.6 percent, $3.00 on an average of $26.49 is 11.3 percent, and the elasticity is negative 1.73. Use one method consistently across products.
Elasticity is not a constant. A product can be inelastic between $22 and $25 and sharply elastic above $28, where it crosses a competitor's price or a shopper's mental threshold. A measurement from one change describes that change only.
It also depends on everything else that moved. A competitor stocking out during the test makes demand look inelastic. A coupon on a rival's listing makes it look elastic. Without matched windows and a seasonal baseline, a measured elasticity is mostly noise.
And it describes the short run. Volume lost to a higher price can show up later as lower search rank, which no four-week comparison captures.
Measuring elasticity needs clean per-SKU history: units, net price, and every fee and refund by date. ConnectBooks reconciles marketplace settlements and reports profit by SKU and channel, which is the data the calculation runs on.
Crunch, the AI analyst inside ConnectBooks, takes pricing investigations as questions: whether a price change made money, which week was most profitable and why. It compares the periods before and after, finds what else changed, and recommends a next step. It cannot estimate elasticity at a price you have never charged, because there is no data there. It does not see competitor prices or search rank. And it reports what happened in your history, not a demand curve for prices you have not tested.
Neither, until you compare it with the break-even figure for the price change in question. On a thin-margin product the break-even can sit near negative 2 or beyond, so negative 1.5 still means a price increase pays. On a high-margin product the break-even sits closer to zero, and the same negative 1.5 means the increase loses money.
Large enough that the volume response stands out from ordinary week-to-week variation. A 2 percent change on a product whose weekly units swing 15 percent on their own will not produce a readable result.
No. Elasticity varies by product, price range, and competition. A category average is a starting assumption at best, and it should be replaced by each product's own measurement as soon as one exists.
Running an e-commerce business comes with plenty of challenges, but ConnectBooks is here to make your life easier. With real-time insights, seamless integrations, and detailed tracking of your profitability and inventory, you can stay ahead of the game. Whether you’re selling on Amazon, Shopify, Walmart, TikTok or eBay, ConnectBooks helps you manage your finances with 100% accuracy and confidence, so you can focus on growing your business.
Ready to level up? Start making smarter, data-driven decisions every step of the way. Try ConnectBooks Free Today or Schedule a Demo